Trends in Renewable Energy Consumption and Electricity

Total Energy consumption declined for a second year in a row to its lowest level since 1996, dropping 10.1% in industrial areas.

04/12/2011


Despite an economic recession and a significant fall in overall energy demand/consumption, the use of renewable fuels grew strongly in 2009. This growth has been supported by federal and state programs, including federal tax credits, state renewable portfolio standards, and a federal renewable fuels standard. The U.S. Energy Information Administration details renewable energy consumption in 2009 and explains the decrease in total energy consumption over the past two years.

Total U.S. Energy Consumption

U.S. energy consumption declined for the second year in a row in 2009, falling 4.8% between 2008 and 2009 to 94.6 quadrillion British Thermal Units (Btus). This follows a 2.1% decline between 2007 and 2008. As a result, total energy consumption in 2009 dropped to its lowest level since 1996.

This is just the third time since 1949 that energy consumption has declined for two or more consecutive years. It declined between 1973 and 1974 and again in 1975. However, consumption rebounded in 1976 above the 1973 level. The longest and steepest decline occurred between 1979 and 1983, when total energy consumption dropped 9.7% and it did not reach the 1979 level again until 1988.

In both of these earlier periods, oil prices that rose steeply and remained at high levels were a major factor in slowing down the economy and hence reducing energy consumption. This time, there has been no steep oil price increase that resulted in permanently higher oil prices; the average annual price per barrel of crude oil was $60 in 2006, $67 in 2007, $94 in 2008, and $56 in 2009. Instead, the economy slowed down mainly due to factors outside the energy sector.

Consumption of all major fuels declined between 2008 and 2009, except for renewables. Coal dropped the most, falling 12%, while petroleum consumption fell nearly 5%, and natural gas consumption fell 2%. Even nuclear fuel consumption fell by nearly 1%. The decline in all of these sources of energy masks the switching of coal to natural gas for electricity generation due to low natural gas prices.

By sector, energy consumption dropped most in the industrial area (10.1%), followed by electric power (4.5%) and then transportation (3.5%). The residential and commercial sectors each experienced declines of under 2%.

Read more…

- Edited by Gust Gianos, Consulting-Specifying Engineer, www.csemag.com



No comments
The Engineers' Choice Awards highlight some of the best new control, instrumentation and automation products as chosen by...
Each year, a panel of Control Engineering editors and industry expert judges select the System Integrator of the Year Award winners.
Control Engineering Leaders Under 40 identifies and gives recognition to young engineers who...
Learn more about methods used to ensure that the integration between the safety system and the process control...
Adding industrial toughness and reliability to Ethernet eGuide
Technological advances like multiple-in-multiple-out (MIMO) transmitting and receiving
Virtualization advice: 4 ways splitting servers can help manufacturing; Efficient motion controls; Fill the brain drain; Learn from the HART Plant of the Year
Two sides to process safety: Combining human and technical factors in your program; Preparing HMI graphics for migrations; Mechatronics and safety; Engineers' Choice Awards
Detecting security breaches: Forensic invenstigations depend on knowing your networks inside and out; Wireless workers; Opening robotic control; Product exclusive: Robust encoders
The Ask Control Engineering blog covers all aspects of automation, including motors, drives, sensors, motion control, machine control, and embedded systems.
Join this ongoing discussion of machine guarding topics, including solutions assessments, regulatory compliance, gap analysis...
News and comments from Control Engineering process industries editor, Peter Welander.
IMS Research, recently acquired by IHS Inc., is a leading independent supplier of market research and consultancy to the global electronics industry.
This is a blog from the trenches – written by engineers who are implementing and upgrading control systems every day across every industry.
Anthony Baker is a fictitious aggregation of experts from Callisto Integration, providing manufacturing consulting and systems integration.
Integrator Guide

Integrator Guide

Search the online Automation Integrator Guide
 

Create New Listing

Visit the System Integrators page to view past winners of Control Engineering's System Integrator of the Year Award and learn how to enter the competition. You will also find more information on system integrators and Control System Integrators Association.

Case Study Database

Case Study Database

Get more exposure for your case study by uploading it to the Control Engineering case study database, where end-users can identify relevant solutions and explore what the experts are doing to effectively implement a variety of technology and productivity related projects.

These case studies provide examples of how knowledgeable solution providers have used technology, processes and people to create effective and successful implementations in real-world situations. Case studies can be completed by filling out a simple online form where you can outline the project title, abstract, and full story in 1500 words or less; upload photos, videos and a logo.

Click here to visit the Case Study Database and upload your case study.