Power control systems

Russelectric on-site power control systems are equipped with dual programmable logic controls (PLCs) for automatic generator set starting and stopping, status and alarm annunciation, synchronizing, and priority load control.

05/14/2013


Russelectric on-site power control systems are equipped with dual programmable logic controls (PLCs) for automatic generator set starting and stopping, status and alarm annunciation, synchronizing, and priority load control. Courtesy: RusselectricAll Russelectric on-site power control systems are equipped with dual programmable logic controls (PLCs) for automatic generator set starting and stopping, status and alarm annunciation, synchronizing, and priority load control. A primary PLC system operation with a backup PLC running the same program as the primary. If the primary PLC fails, the backup PLC assumes operational control. If both PLCs were to fail, a manual control system allows operating personnel to synchronize and parallel the generators onto the bus, as well as to add and shed load. This built-in redundancy is included in all Russelectric on-site power control systems. The instruments and other devices that facilitate manual operation (including generator main bus volt meter, frequency meter, and synchroscope) are mounted on a hinged panel that can be specified to swing either left or right for easy viewing from adjacent control cubicles during manual operation. Russelectric custom designs and builds power control and synchronizing switchgear systems in low- and medium-voltage ratings for single- and multi-unit on-site power generators. 

Russelectric 

www.russelectric.com



No comments