Photovoltaic module shipments surge in the fourth quarter of 2012

A new PV module shipment record of 11 GW was reached in the fourth quarter.

01/15/2013


IHS After a disastrous third quarter of 2012 featuring extremely low factory utilization rates across the entire photovoltaic (PV) supply chain, a surge in demand was seen in the final quarter of the year for PV modules. A new PV module shipment record of 11 GW was reached in the fourth quarter according to the IHS Solar Integrated Market Tracker from information and analytics provider IHS. Despite this positive sign the situation of the global PV industry remains critical and a substantial recovery of the supply-demand balance is not expected to occur before the second half of 2013.

PV markets rebound sharply in the fourth quarter of 2012

The third quarter of 2012 dealt another blow to the global photovoltaic industry. After a relatively strong second quarter resulting in global installations of 7.8 GW, markets softened again. “Installations in the third quarter amounted to just 7.5 GW. Wholesalers, EPCs, and PV suppliers were forced to carefully control their inventory levels due to falling prices and low shipment levels and production cuts were the consequence,” commented Principal Analyst Stefan de Haan. In the third quarter of 2012, average module capacity utilization fell to 49 percent, cell capacity utilization to 56 percent, wafer capacity utilization to a record-low 55 percent, and polysilicon capacity utilization to 63 percent. In parallel, prices continued their slide in the third quarter of 2012 resulting in module industry revenues of only $6.0 billion—the lowest value since the second quarter of 2009. These difficult conditions were reflected in an increasing number of suppliers exiting the market.

“In the fourth quarter of 2012 global PV markets rebounded sharply. Very strong demand from Asia, with the surge driven largely by China and Japan, helped to compensate for sluggish demand in Europe. IHS estimates that global PV installations were 10.1 GW in the fourth quarter of 2012. In particular leading Chinese module suppliers benefited from the uptick in demand and shipped much more than previously expected,” explained de Haan. In total, 11.0 GW of global module shipments are estimated for the fourth quarter of 2012 - a new record for the industry. As anticipated by IHS, average market pricing for crystalline modules declined to $0.65 per watt at the end of 2012, down from $0.70 at the end of September. Importantly, however, the price decline lost momentum in the course of the fourth quarter. Towards the end of the year some module prices even increased. Record-level shipments paired with stabilizing prices drove a profound recovery of revenues. According to the IHS Solar Integrated Market Tracker, fourth quarter 2012 module revenues grew by a stunning 42 percent quarter-over-quarter, reaching $8.5 billion.

Suppliers will experience seasonal weakness in the first quarter of 2013

In the first quarter of 2013 suppliers are predicted to experience the usual seasonal weakness of global solar markets. Global PV installations are forecast to drop to 6.7 GW in this quarter. As a result upstream shipments and revenues will temporarily come under pressure again. With prices forecast to decrease by another 4 -5 percent in the first quarter of 2013 (compared to the fourth quarter of 2012), module revenues will fall back to the critical levels of the third quarter of 2012—or even below. This will force more suppliers to review their business models and eventually leave the solar market.

2013 will be the year of the turnaround

After a tough first quarter, a substantial increase in global demand is forecast to drive increasing revenues and stabilizing prices in the second half of 2013. IHS forecasts 35 GW of global installations in 2013, up 10 percent over 2012. Although this level of growth is lower than previous years, it will drive a continuous improvement of shipments and revenues in the polysilicon to module supply chain throughout 2013. Recent positive signals from authorities in several key markets like China and France raise hopes for the recovery of the PV industry to happen even faster. “Whilst it’s too early to give the all-clear for the PV supplier industry, there is increasing indication that the year 2013 will mark the turnaround,” concluded de Haan.

The chart below presents a forecast of global shipments of the photovoltaic module industry (crystalline and thin film).

Source: IHS January 2013



No comments
The Engineers' Choice Awards highlight some of the best new control, instrumentation and automation products as chosen by...
Each year, a panel of Control Engineering editors and industry expert judges select the System Integrator of the Year Award winners.
The Engineering Leaders Under 40 program identifies and gives recognition to young engineers who...
Learn how to increase device reliability in harsh environments and decrease unplanned system downtime.
This eGuide contains a series of articles and videos that considers theoretical and practical; immediate needs and a look into the future.
Learn how to create value with re-use; gain productivity with lean automation and connectivity, and optimize panel design and construction.
Go deep: Automation tackles offshore oil challenges; Ethernet advice; Wireless robotics; Product exclusives; Digital edition exclusives
Lost in the gray scale? How to get effective HMIs; Best practices: Integrate old and new wireless systems; Smart software, networks; Service provider certifications
Fixing PID: Part 2: Tweaking controller strategy; Machine safety networks; Salary survey and career advice; Smart I/O architecture; Product exclusives
The Ask Control Engineering blog covers all aspects of automation, including motors, drives, sensors, motion control, machine control, and embedded systems.
Look at the basics of industrial wireless technologies, wireless concepts, wireless standards, and wireless best practices with Daniel E. Capano of Diversified Technical Services Inc.
Join this ongoing discussion of machine guarding topics, including solutions assessments, regulatory compliance, gap analysis...
This is a blog from the trenches – written by engineers who are implementing and upgrading control systems every day across every industry.
IMS Research, recently acquired by IHS Inc., is a leading independent supplier of market research and consultancy to the global electronics industry.

Find and connect with the most suitable service provider for your unique application. Start searching the Global System Integrator Database Now!

Case Study Database

Case Study Database

Get more exposure for your case study by uploading it to the Control Engineering case study database, where end-users can identify relevant solutions and explore what the experts are doing to effectively implement a variety of technology and productivity related projects.

These case studies provide examples of how knowledgeable solution providers have used technology, processes and people to create effective and successful implementations in real-world situations. Case studies can be completed by filling out a simple online form where you can outline the project title, abstract, and full story in 1500 words or less; upload photos, videos and a logo.

Click here to visit the Case Study Database and upload your case study.