PV storage market set to explode to $19 billion in 2017; Germany leads again

The worldwide market for PV storage is forecast to grow rapidly to reach $19 billion in 2017.

05/21/2013


IMS Research (acquired by IHS, Inc.)The worldwide market for PV storage is forecast to grow rapidly to reach $19 billion in 2017, from less than $200 million in 2012, according to a new report entitled "The Role of Energy Storage in the PV Industry" from IMS Research, now part of IHS Inc.

Following the introduction of an energy storage subsidy in Germany, global installations of PV storage systems are forecast to grow by more than 100% a year on average over the next five years, to reach almost 7 GW in 2017 and worth $19 billion. Germany will account for nearly 70% of storage installed in residential PV systems worldwide in 2013.However, opportunities also will exist in other regions and applications in the future and Germany’s share of the global market naturally will fall as a result.

The figure below shows the IHS forecast for global PV storage system market revenue.

Source: IMS Research (acquired by IHS, Inc.)

Subsidy to accelerate growth in Germany

Germany’s long-awaited subsidy for PV storage systems is due to launch on May 1st. IHS predicts that the subsidy will promote rapid growth in the German residential sector, and result in almost 2 GWh of effective storage capacity being installed during the next five years.

"Because domestic electricity rates now significantly exceed residential feed-in tariff rates, there is strong interest in increasing self-consumption in residential PV systems to maximize the financial return of the system," said Sam Wilkinson, PV analyst at IHS. "As a result, 8 MW of PV systems were already installed with storage in Germany in 2012, prior to the subsidy being released. The introduction of the widely anticipated subsidy will quickly accelerate uptake by making the lifetime cost of PV systems with storage cheaper compared to those without it."

Although the rates are not confirmed yet, the proposed subsidy will reduce the average 20-year cost of a PV system with storage to 10% less than a system without it.

Previously, the high cost of batteries had more than offset the savings created by increased self-consumption, and PV systems without storage offered a more attractive return.

Will other countries follow Germany’s lead again?

While Germany is forecast to remain one of the largest markets for PV storage, energy storage solutions will also be deployed in a wide range of other regions, the report found. Germany was the pioneer of the FiT for PV systems and along with Japan initially drove the PV market’s development.

Source: IMS Research (acquired by IHS, Inc.)

As the first country to introduce a subsidy for PV storage, Germany will inspire other countries to follow suit, if the scheme proves successful, IHS expects.

"We do expect that other countries will follow Germany’s example and adopt similar subsidy schemes to promote the use of PV energy storage—particularly where there is a case for promoting self-consumption and grid stability," Wilkinson said. "Even without subsidies though, storage can be an attractive proposition in conjunction with residential PV systems in some markets, such as the U.K., where the market is forecast to begin growing quickly in 2014, when the price of batteries is predicted to have fallen sufficiently to make PV storage financially viable."

Storage is also predicted to be used in larger systems, in order to improve the integration of PV into the grid, increase the financial return of PV systems and meet the increasingly demanding connection requirements that some countries are imposing on intermittent electricity sources like PV. Utility-scale PV systems with storage are forecast to grow to more than 2 GW annually by 2017 according to the report, with Asia and the Americas dominating this market.



No comments
The Engineers' Choice Awards highlight some of the best new control, instrumentation and automation products as chosen by...
Each year, a panel of Control Engineering editors and industry expert judges select the System Integrator of the Year Award winners.
Control Engineering Leaders Under 40 identifies and gives recognition to young engineers who...
Learn more about methods used to ensure that the integration between the safety system and the process control...
Adding industrial toughness and reliability to Ethernet eGuide
Technological advances like multiple-in-multiple-out (MIMO) transmitting and receiving
Virtualization advice: 4 ways splitting servers can help manufacturing; Efficient motion controls; Fill the brain drain; Learn from the HART Plant of the Year
Two sides to process safety: Combining human and technical factors in your program; Preparing HMI graphics for migrations; Mechatronics and safety; Engineers' Choice Awards
Detecting security breaches: Forensic invenstigations depend on knowing your networks inside and out; Wireless workers; Opening robotic control; Product exclusive: Robust encoders
The Ask Control Engineering blog covers all aspects of automation, including motors, drives, sensors, motion control, machine control, and embedded systems.
Join this ongoing discussion of machine guarding topics, including solutions assessments, regulatory compliance, gap analysis...
News and comments from Control Engineering process industries editor, Peter Welander.
IMS Research, recently acquired by IHS Inc., is a leading independent supplier of market research and consultancy to the global electronics industry.
This is a blog from the trenches – written by engineers who are implementing and upgrading control systems every day across every industry.
Anthony Baker is a fictitious aggregation of experts from Callisto Integration, providing manufacturing consulting and systems integration.
Integrator Guide

Integrator Guide

Search the online Automation Integrator Guide
 

Create New Listing

Visit the System Integrators page to view past winners of Control Engineering's System Integrator of the Year Award and learn how to enter the competition. You will also find more information on system integrators and Control System Integrators Association.

Case Study Database

Case Study Database

Get more exposure for your case study by uploading it to the Control Engineering case study database, where end-users can identify relevant solutions and explore what the experts are doing to effectively implement a variety of technology and productivity related projects.

These case studies provide examples of how knowledgeable solution providers have used technology, processes and people to create effective and successful implementations in real-world situations. Case studies can be completed by filling out a simple online form where you can outline the project title, abstract, and full story in 1500 words or less; upload photos, videos and a logo.

Click here to visit the Case Study Database and upload your case study.