DIN-rail-mount power supply

DIN-rail-mount power supply module can connect two power supplies in 1+1 redundancy. DLP-PU series is applicable to process control and critical monitoring equipment where downtime would cause extensive and costly manufacturing delay. Module accepts up to two 20-Amp inputs rated between 21 V and 28 V, and contains o-ring diodes to isolate the effects of a faulty power supply on the system bus.

By Staff January 1, 2005

DIN-rail-mount power supply module can connect two power supplies in 1+1 redundancy. DLP-PU series is applicable to process control and critical monitoring equipment where downtime would cause extensive and costly manufacturing delay. Module accepts up to two 20-Amp inputs rated between 21 V and 28 V, and contains o-ring diodes to isolate the effects of a faulty power supply on the system bus. LEDs indicate input status. Status of each output can be monitored using the power supply’s normally open or normally closed relay contacts; a fault is indicated if the input falls below 19.2 V or rises above 20 V. www.lambdapower.com Invensys Lambda