BinderBus seeks to spark distributed network revolution

For a decade, distributed device networks promised dramatically lower costs and more openness. However, technological limits kept market penetration slight and slowed growth, even though many device networks were eventually established.

SerCoNet Ltd. (Netanya, Israel) says these constraints include buses that: sacrifice data-rate to allow longer distance; use master/slave communications and numerous nodes to achieve determinism; or increase distance with costly fiber-optics and coaxial cable. To overcome these limits, SerCoNet recently introduced its ‘BinderBus’ architecture.

The firm reports BinderBus supports unlimited nodes distributed over an unlimited distance. Different topologies, like ring or trunk line with drops, can be chained together. The network can be configured as master/slave or peer-to-peer. There are built-in diagnostics and troubleshooting. The data rate is 1 to 5 Mbs over unshielded twisted pair (UTP) cable.

Node is the key

The key to BinderBus is its patented node, an all-in-one microcontroller, power supply, and network repeater. Inventor and company ceo, Yehuda Binder, says the most effective networks are based on point-to-point communications. BinderBus’ basic principle is that each network segment connects only two nodes with the 22- to 26-AWG UTP carrying power and data. Nodes are connected to field devices. Each network segment is independent of the rest of the network. Since each node can be a power supply, overall network range is extended. Network protocol is TCP/IP modified to support determinism.

BinderBus nodes include a network’s three necessary elements: transceiver chip set, data-link handling, and software driver. A node is slightly larger than a cigarette pack and can be DIN-rail mounted or integrated in devices.

Each node has three network interface ports connected only to another BinderBus node. Power input and output ports are included. There is an RS-232 port for PC or PLC connection. Eight programmable inputs and eight programmable outputs are programmable for discrete or analog (4-20 mA or 0-5 V dc). A plug-in interface port allows Ethernet, other buses, or video/audio to be added.

Bandwidth can be segmented into master/slave and peer-to-peer. Part of the network can be deterministic master/slave for control leaving the rest of the bandwidth for peer-to-peer data communications. The partition can vary from network to network, or within the same network at different times.

If a failure occurs, such as a short or open line, the network immediately determines its location for quicker repairs. Each node retains its I/O function control, and the network remains active in all nodes still connected. Short-circuit protection and EMF filters enhance network and data reliability.

Node numbers are assigned automatically. One node, preferably the one to which the programming platform (PC) is connected, is assigned number 128. The node connected to the left port recognizes its position and assigns itself address 127 and so on. Likewise, nodes connected to the right are assigned addresses in ascending order. Adding or removing nodes is immediately detected and their exact locations are identified.

BinderBus can connect different network types and topologies within its network architecture.

For more information, visit www.controleng.com/freeinfo .

Do you have experience and expertise with the topics mentioned in this content? You should consider contributing to our WTWH Media editorial team and getting the recognition you and your company deserve. Click here to start this process.